Use Of Internal Water Dispenser And Water Dispenser At The Door; Dispensing Water - Beko GN1406231XBN Mode D'emploi

Operating the product
5.17 Use of internal water dispenser
and water dispenser at the door
(in some models)
After connecting the refrigerator to a water source
or replacing the water filter, flush the water
system. Use a sturdy container to depress and
hold the water dispenser lever for 5 seconds,
then release it for 5 seconds. Repeat until water
begins to flow. Once water begins to flow, continue
depressing and releasing the dispenser paddle
(5 seconds on, 5 seconds off) until a total of 4
gal. (15L) has been dispensed. This will flush air
from the filter and water dispensing system, and
prepare the water filter for use. Additional flushing
may be required in some households. As air is
cleared from the system, water may spurt out of
the dispenser.
Allow 24 hours for the refrigerator to cool down
and chill water. Dispense enough water every week
to maintain a fresh supply.
After 5 minutes of continuous
dispensing, the dispenser will stop
C
dispensing water to avoid flooding.
To continue dispensing, press the
dispenser paddle again.
Water dispenser at the door (in some models)
Quick Cool
Select
3 "
Quick Cool
Select
3 "
Quick Freeze
3 "
FN
OK
Quick Freeze
3 "
FN
OK
27/ 30 EN

5.18 Dispensing water

Hold a container under the dispenser spout while
pressing the dispenser pad.
Release the dispenser pad to stop dispensing.
C
Quick Cool
It is normal for the first few glasses of
Select
water taken from the dispenser to be
3 "
warm.
C
If the water dispenser is not used for a long
period of time, dispose of first few glasses
of water to obtain fresh water.
During initial use, you will have to wait
approximately 24 hours for the water to cool down.
Take out the glass a little while after you pull the
trigger.
Quick Cool
Select
3 "
Built-in water dispenser (in some models)
Quick Freeze
3 "
FN
OK
Quick Freeze
3 "
FN
OK
Refrigerator / User Manual