Water Connection; Attaching/Removing The Internal Filter To/From - Beko BBBF3019IMWESS Manuel D'utilisation

Operating the Product

5.14 Water connection

(May not be available in all models)
Your refrigerator may be equipped with an external
or internal filter. Look at the figures below and
follow the instructions to install the water filter:
Please see the installation instruction
A
to connect the product to the mains.
5.15 Attaching/Removing the Internal
Filter to/from the Refrigerator
First of all, turn "OFF" the ice machine and water
dispenser from the control display of the product.
To install the filter to the product:
1. Slightly press the front side of the water filter lid,
which is located at the top-left corner of the fresh
food compartment, to open it.
2. As seen in the figure, push the water filter into its
slot in an angled position. Then keep the filter in a
horizontal position and press on the lid to close it.
To remove the filter from the product:
1. Slightly press the front side of the water filter lid,
which is located at the top-left corner of the fresh
food compartment, to open it.
2. Keep the water filter in a downwards angled
position, pull it towards yourself and remove it.
C
It is normal that a few drops of water
drip after the water filter has been
removed.
3. Slightly push the water filter lid upwards to close it.
4. Select the "ON" mode to exit this mode.
If you want to use the ice machine and the water
dispenser without the water filter, install the by-
pass cover the same way you install the water
filter.
C
The water dispenser or ice machine
can never be used without the water
filter or by-pass cover installed.
Otherwise, water will come out from
that part.
24 / 35 EN
Refrigerator / User Manual