Start-Up; On / Off Cycling Of Compressor; Click-To-Set Regulator Knob - Campbell Hausfeld WL675000 Instructions D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operating Instructions and Parts Manual
Operation (Continued)

start-uP

Pull safety relief valve before filling to be sure the valve
moves freely.
The tank manifold gauge does not indicate the pressure in the object
being filled. Use a separate gauge to check the object.

on / oFF cycLIng oF coMPressor

In the ON position, the compressor pumps air into the tank. When a shut-off (preset
"cut-out") pressure is reached, the compressor automatically shuts off.
If the compressor is left in the ON position and air is depleted from the tank by use of
a tire chuck, tool, etc., the compressor will restart automatically at its preset "cut-in"
pressure. When a tool is being used continuously, the compressor will cycle on and off
automatically.
In the OFF position, the pressure switch cannot function and the compressor will not
operate. Make sure switch is in OFF position when connecting or disconnecting power
cord from electrical outlet.

cLIck-to-set reguLator knoB

This knob controls air pressure to an air operated tool, or paint spray gun.
u
Turning knob clockwise increases air pressure at outlet.
u
Turning counterclockwise will lower air pressure at outlet.
u
Fully counterclockwise will shut off flow of air completely.
u
This regulator knob is designed to rotate approximately 270 degrees for all feature
settings. If the knob is rotated past minimum operation setting (counterclockwise), the
knob will no longer "click" as designed to indicate that the regulator has been placed
in a specific setting. The outlet pressure will read zero (0 psi) once the knob is at the
minimum operation setting. Continuous turning of the regulator knob past minimum
operation setting (counterclockwise) could result in the regulator knob coming loose
and detaching.
If outlet pressure gauge is at zero (0) psi,
DO NOT turn knob counterclockwise.
If regulator knob is turned and a "click" is no longer heard,
DO NOT turn knob counterclockwise.
Figure 14
12
www.chpower.com
Regulator Spring
Regulator Body
WL675000
Retaining Latch
Regulator Knob

Publicité

Table des Matières
loading

Table des Matières