Kenwood STZ-RF200WD Manuel D'instructions page 18

Adjusting the field of view
1. Open the KENWOOD Motorsports CAM and tap "Image angle adjustment" on the main menu.
It will start with the live feed from the front camera.
• Tap "Rear" to switch to the live feed from the rear camera.
• Tap "X" when you are finished with the screen.
• If it starts with the live feed from the rear camera, the front and rear camera connections are
incorrect. Check the camera cable connections.
2. Use the included hex key to loosen the bolt on the installation bracket.
3. Rotate the camera while checking the live feed and adjust the camera to your preferred field of view.
Make sure that the indentation on the back of the camera is facing up.
4. Once the adjustment is complete, tighten the bolt and lock the camera in place.
Bolt
18
Guide lines