Kenwood STZ-RF200WD Manuel D'instructions page 13

• GPS antenna
Install the GPS device in a location where it can easily receive satellite signals, such as near the handle-
bars or on top of the gas tank. Remove the release paper from the double-sided tape before installing.
• Switch
Install the switch in a location that is easy to operate and will not interfere with safe operation of the
motorcycle, such as on or nearby the left handlebar.
  R emove the release paper from the double-sided tape before installing.
• Front and rear cameras
Install the cameras in locations where the field of view will not be affected by the motorsports vehicle
itself.
  R emove the protective film from the double-sided tape before installing. Use screws, nuts (not includ-
ed), and cable ties as needed to secure the cameras in place.
  A fter installation, use the KENWOOD Motorsports CAM App to check the video feed and adjust the
camera. See p. 1 8 "Adjusting the field of view" for more details.
• When using double-sided tape to install the unit, remove dirt and fingerprints from the installation
location using a commercial cleaning cloth and wait for the location to dry before proceeding. Re-
using tape or using general purpose double-sided tape for installation will provide less adhesive
power and presents a risk of the unit falling off.
• Use cable ties to secure cables so that they do not droop. Improper wiring or securing could
result in wires falling, malfunctions, fires, or accidents.
13