Status Led Function; Audio Warning Tones - Team Orion R8 ONE Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

before proceeding with the calibration. Follow the procedure
below to calibrate your ESC
A. Switch off the ESC and switch the transmitter on,
B. Press and hold the SET button (located on the ESC's
switch), then switch on the ESC. Release the SET button as
soon as the red LED starts to flash.
C. Calibrate the throttle points by pressing the SET button
once after each step.
1. neutral point (1 green flash)
2. full throttle (2 green flashes)
3. full brakes/reverse (3 green flashes)
D. The motor will run 3 seconds after the last step is
completed.

STATUS LED FUNCTION

• In the neutral position, no LED are lit.
• The red LED lights when the car is moving forward,
backwards or when braking.
• At full throttle the green LED is lit.

AUDIO WARNING TONES

1. Input voltage problem: ESC checks the input voltage as
it is switched on, if a problem is detected, the ESC emits
repeatedly two beeps with a 1 second pause and the
green LED flashes simultaneously (xx-xx-xx).
2. Radio signal problem: ESC checks the radio signal input as
it is switched on, if a problem is detected, the ESC emits
repeatedly a beep with a 2 second pause and the green
LED flashes simultaneously (x-x-x).
10
Copyright Team Orion © 2015

Publicité

Table des Matières
loading

Table des Matières