Rockford Fosgate RFX Serie Manuel D'installation Et Fonctionnement page 21

S
YMPTOM
Tuner has poor
reception
Disc will not load
into Source Unit
(also see error
codes)
Disc will not eject
(also see error
codes)
ERROR 1
(Initialize Error)
ERROR 3
(Loading Error)
ERROR 4
(Eject Error)
ERROR 6
(Transverse Error)
ERROR 7
(Servo Error)
ERROR 9
(TOC Error)
D
IAGNOSIS
Antenna is disconnected or not
properly grounded to vehicle
Antenna cable is intermittent or
damaged
Antenna is wrong type for
AM/FM frequencies
Voltage applied to Red and
Yellow wires is not between
10.8 and 16 volts or there is no
voltage present
Voltage applied to Yellow wire is
not between 10.8 and 16 volts
or there is no voltage present
No initialization
Mechanism is jammed and
loading motor (or driving circuit)
is defective
Foreign objects are preventing
the disc from loading
Loading area in mechanism and
loading motor (or driving circuit)
is defective
Foreign objects are preventing
disc from ejecting
Eject area in mechanism and
ejecting motor (or driving circuit)
is defective
Transverse motor or switch is
defective or Traverse area of disc
is damaged
Excessive dirt or dust on disc
Disc is warped, cracked,
damaged or severely scratched
Disc is cracked, warped or
severely damaged
Laser pickup is defective
Servo unit in CDP mechanism is
not operating properly
R
EMEDY
Check connections and installation of antenna
and repair or replace as necessary
Disconnect antenna and test with known
working antenna. If tuner works, check
installation and repair antenna as necessary
Consult your local Authorized Rockford
Fosgate Dealer for proper antenna selection
Check battery, connections and fuses, and
repair or replace as necessary. If voltage is
above +16 volts, have the electrical system
inspected by an authorized car service center
Check battery, connections and fuses, and
repair or replace as necessary. If voltage is
above +16 volts, have the electrical system
inspected by an authorized car service center
Press the reset button
Repair the mechanism and
loading motor (or driving circuit)
Check CDP mechanism load area by
removing faceplate and repair as necessary
Repair the mechanism and loading motor
(or driving circuit)
Check CDP mechanism eject area by
removing faceplate and repair as necessary
Repair the mechanism and loading motor (or
driving circuit)
Check CD mechanism motor and switch.
Put in a different disc!
Clean disc to remove dirt or dust as necessary
Put in a different disc!
Put in a different disc!
Have service center repair laser pickup
Check the servo circuit area and repair as
necessary
T
ROUBLESHOOTING
21