Ego Power+ BC1500E-F Manuel D'utilisation page 9

ASSEMBLY
WARNING:
If any parts are damaged or missing,
do not operate this product until the parts are replaced.
Use of this product with damaged or missing parts could
result in serious personal injury.
WARNING:
Do not attempt to modify this product
or create accessories not recommended for use with
this line trimmer. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.
WARNING:
To prevent accidental starting that could
cause serious personal injury, always remove the battery
pack from the tool when assembling parts.
MOUNTING AND ADJUSTING THE BIKE HANDLE
The trimmer is stored in such position (Fig. B). Loosen the
wing bolt on the connecting joint firstly and then lift the
bike handle 180° around the shaft (Fig. C), turn it 90°
anticlockwise to make it face the bump head (Fig. D).
Lastly, rotate it back and forth to reach a comfortable
working position and tighten the bolt.
MOUNTING THE GUARD
WARNING:
Always wear gloves when mounting or
replacing the guard. Take care of the blade on the guard
and protect your hand from cutting.
WARNING:
Never operate the tool without the
guard firmly in place. The guard must always be on
the tool to protect the user! When the guard was fixed,
never attempted to remove or adjust the guard, if replace
needed, it shall be performed by a qualified service
technician!
Loosen and remove the two screws from the shaft base
(Fig. E), align the guard mounting holes with the assembly
holes and then lock the guard onto the shaft base with the
two screws, together with two spring washers (Fig. F).
Make sure the guard is fixed according to Fig. E & F, any
reverse fixing will cause great danger!
MOUNTING THE SHOULDER STRAP
Press the hook of the strap and hang it onto the tubing
clip fixed on the shaft (Fig. G).
56 VOLT LITHIUM-ION BRUSHLESS BIKE HANDLE LINE TRIMMER — BC1500E-F
OPERATION
WARNING:
Do not allow familiarity with this
product to make you careless. Remember that a careless
fraction of a second is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side
shields along with hearing protection. Failure to do so
could result in objects being thrown into your eyes and
other possible serious injuries.
WARNING:
Do not use any attachments or
accessories not recommended by the manufacturer of
this product. The use of attachments or accessories not
recommended can result in serious personal injury.
WARNING:
Use your line trimmer equipped with the
appropriate cutting line only for cutting grass and similar
material.
You may use this product for the purposes listed below:
Trimming: used for removing grass and weeds up against
walls, fences, trees and borders.
Cutting: used for cutting the grass that is difficult to
reach using a normal mower.
NOTICE:
The tool is to be used only for its prescribed
purpose. Any other use, for example edge trimming, is
deemed to be a case of misuse.
ATTACHING/DETACHING THE BATTERY PACK
Fully charge before first use.
To Attach
Align the battery ribs with the mounting slots and press the
battery pack down until you hear a "click" (Fig. H).
To Detach
Depress the battery-release button and pull the battery
pack out (Fig. I).
HOLDING THE LINE TRIMMER
WARNING:
Dress properly to reduce the risk of
injury when operating this tool. Do not wear loose
clothing or jewelry. Wear eye and ear/hearing protection.
Wear heavy duty, long trousers, boots and gloves. Do not
wear short trousers, sandals or go barefoot.
Before operating, look around you to ensure a safety
working area without other people, animals or any loose
objects. And then check for eye protection, proper clothing
and balanced footing.
EN
9