Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7
Mount the station
+
Hang the station on the screw using the notch on the back of the station
+
Using the Torx driver bit, drive the remaining 2 screws into the bottom
mounting holes or anchors to secure the station
Side view
8
Wire the station
+
Install the ducting connector or strain relief, as appropriate
+
Trim the service wiring to remove excess length while
ensuring that the wiring can easily reach the connectors on
the charging station's terminal block
+
Strip each wire 13 mm
+
Fully insert wires into the connectors on the left side of the
terminal block, as shown
+
On each connector, press the white levers all the way down
until it snaps into place
CAUTION: Ensure each wire is fully inserted into the
connector before snapping down the white levers. The metal
wire should not be visible.
L1 GND N
6 chargepoint.com
Front view
L1 GND N
Tip: Keep fingers away
from underneath the
white levers as you snap
them down.
Strip
13 mm
Publicité
Table des Matières
