Additional Safety Instructions For Batteries And Chargers - Black & Decker AS36LN Traduction Des Instructions D'origine

lack of experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that
♦
they do not play with the appliance.
Vibration
The declared vibration emission values stated in
the technical data and the declaration of conformity
have been measured in accordance with
a standard test method provided by EN 60745
and may be used for comparing one tool with
another. The declared vibration emission value
may also be used in a preliminary assessment
of exposure.
Warning! The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which
the tool is used. The vibration level may increase
above the level stated.
When assessing vibration exposure to determine
safety measures required by 2002/44/EC to
protect persons regularly using power tools in
employment, an estimation of vibration exposure
should consider, the actual conditions of use and
the way the tool is used, including taking account
of all parts of the operating cycle such as the times
when the tool is switched off and when it is running
idle in addition to the trigger time.
Labels on tool
The following pictograms are shown on the tool:
Warning! To reduce the risk of injury, the
user must read the instruction manual.
Additional safety instructions for batteries
and chargers
Batteries
Never attempt to open for any reason.
♦
Do not expose the battery to water.
♦
Do not expose the battery to heat.
♦
Do not store in locations where the
♦
temperature may exceed 40 °C.
Charge only at ambient temperatures between
♦
10 °C and 40 °C.
Charge only using the charger provided with
♦
the appliance/tool. Using the wrong charger
could result in an electric shock or overheating
of the battery.
When disposing of batteries, follow the
♦
instructions given in the section "Protecting the
environment".
Do not damage/deform the battery either by
♦
puncture or impact, as this may create a risk of
injury and fi re.
Do not charge damaged batteries.
♦
Under extreme conditions, battery leakage
♦
may occur.
When you notice liquid on the batteries
carefully wipe the liquid off using a cloth. Avoid
skin contact.
In case of skin or eye contact, follow the
♦
instructions below.
Warning! The battery fl uid may cause personal
injury or damage to property. In case of skin
contact, immediately rinse with water. If redness,
pain or irritation occurs seek medical attention. In
case of eye contact, rinse immediately with clean
water and seek medical attention.
Chargers
Your charger has been designed for a specifi c
voltage.
Always check that the mains voltage corresponds
to the voltage on the rating plate.
Warning! Never attempt to replace the charger
unit with a regular mains plug.
Use your BLACK+DECKER charger only to
♦
charge the battery in the tool with which it was
supplied. Other batteries could burst, causing
personal injury and damage.
Never attempt to charge non-rechargeable
♦
batteries.
If the supply cord is damaged, it must be
♦
replaced by the manufacturer or an authorised
BLACK+DECKER Service Centre in order to
avoid a hazard.
Do not expose the charger to water.
♦
Do not open the charger.
♦
Do not probe the charger.
♦
The appliance/tool/battery must be placed in
♦
a well ventilated area when charging.
The charger is intended for indoor use
only.
Read the instruction manual before use.
The charger automatically shuts off if the
ambient temperature becomes too high.
The thermal cut out operates only once
and then requires complete replacement.
ENGLISH
49