Philips AVENT SCD510 Mode D'emploi page 15

Question
Why is the connection lost
every now and then? Why
are there sound
interruptions?
What happens during a
power failure?
Is my baby monitor secure
from eavesdropping and
interference?
The operating time of the
parent unit is supposed to
be up to 24 hours. Why is
the operating time of my
parent unit shorter?
Why doesn't the
battery light of the parent
unit light up when I start to
recharge the parent unit?
Answer
The baby unit and the parent unit are probably close to the outer
limits of the operating range. Try a different location or decrease the
distance between the units. Please note that it takes about 30
seconds each time before a connection between the units is
established.
If the parent unit is sufficiently charged, it continues to operate
during a power failure, both connected to and disconnected from
the adapter. If there are batteries in the baby unit, it also continues
to operate during a power failure.
The DECT technology of this baby monitor guarantees no
interference from other equipment and no eavesdropping.
When the parent unit has been charged for the first time, the
operating time is less than 24 hours. The rechargeable batteries only
reach their full capacity after you have charged and discharged
them at least four times.
The volume of the parent unit may be set too high, which causes
the parent unit to consume a lot of energy. Decrease the volume of
the parent unit
The microphone sensitivity level of the baby unit may be set too
high, which causes the parent unit to consume a lot of energy.
Decrease the microphone sensitivity level with the SENSITIVITY
button on the parent unit.
It may take a few minutes before the battery light of the parent unit
lights up when you charge the parent for the first time or after a
long period of disuse.
EngliSh
15