Jtroubleshooting; J.1 Alarms - Zanussi ZXLIG Instructions D'installation

J TROUBLESHOOTING
J.1 Alarms
Alarm Display message
number
01 TANK FILLING
02 BOILER HEATING
03 TANK HEATING
04 TANK DRAINING
05 BOILER FILLING
06 BOILER PROBE
07 TANK PROBE
08 Thermostop TIME-OUT
09 BOILER SAFETY SWITCH
10 TANK SAFETY SWITCH
12 PANEL CONNECTION
13 PARAMETER ERROR!
15 SERVICE WARNING
Type of anomaly
Tank NOT filling
Boiler NOT heating
Tank NOT heating
Inefficient drainage
Boiler NOT filling
Boiler probe temperature out-
side range
Tank probe temperature out-
side range
Thermostop time-out before
rinse
Boiler safety thermostat
intervention
Tank safety thermostat
intervention
No communication circuit board
The parameters have been
compromised
The number of cycles for main-
tenance reached
Actions
Open the tap.
Clean the water inlet filter.
Make sure drain pipe does not kink, pinch or
twist.
Check the minimum mains pressure.
Insert properly the overflow.
Rinse arm nozzles clogged.
CALL THE SERVICE CENTRE
CALL THE SERVICE CENTRE
Remove the overflow.
Make sure the pump filter is not clogged.
Remove any obstruction from the waste
outlet pipe and/or the overflow aperture.
Open the tap.
Clean the water inlet filter.
Make sure drain pipe does not kink, pinch or
twist.
Check the minimum mains pressure.
CALL THE SERVICE CENTRE
CALL THE SERVICE CENTRE
CALL THE SERVICE CENTRE
CALL THE SERVICE CENTRE
CALL THE SERVICE CENTRE
CALL THE SERVICE CENTRE
CALL THE SERVICE CENTRE
CALL THE SERVICE CENTRE
ENGLISH
19