Connecting The Input Power; Connecting The Loads; Switch On Inverter - Cotek SP Serie Manuel D'utilisation

4-2. Connecting the input power

Before making the DC input side connections
must be at "OFF".

4-3. Connecting the loads

Calculate the total power consumption of the output load. Make sure that
the total power consumption does not exceed the rated power.
If the total power consumption over the rated power of the inverter, remove
the non-critical: loads until the total power consumption is below the rated
power.

4-4. Switch ON Inverter

Set the power switch to the "ON" position
self-diagnosis and, the LED's will also appear various colors.
Set the power switch to the "OFF" position . The inverter stops and all the
lights that are on will go off.
Figure 18. Battery cabling
, the main switch
④
. The inverter will carry out
31