Troubleshooting - Napoleon Luxuria LVX38P2-1 Manuel Du Propriétaire

9.0 troubleshooting

troubleshooting
EN
symptom
Flame is a blue,
lazy, transparent flame
White / grey film forms
on glass.
Exhaust fumes smelled
in room, headaches.
Pilot will not light. Makes
noise with no spark at
pilot burner. (EI only)
Pilot sparks but will
not light.
Battery holder (including
switch) is in "off"
position; burner comes
on.
Remote control and/or
battery holder (including
switch) is not functioning
properly.
Flames are very
aggressive.
Appliance won't
perform any
functions.
Appliance keeps
shutting off.
36
W415-2036 / E / 05.10.22
problem
Blockage in vent.
Sulphur from fuel is being -
ited on glass, logs, or -
depos
surfaces.
Appliance may be leaking
exhaust fumes into the room.
No siginal from remote with no
pilot ignition.
Gas supply.
Out of propane gas.
Remote control (if equipped).
Battery holder (including wall
switch) mounted upside down.
Battery holder (including switch)
and/or wire is grounding.
Faulty wire
Remote control lights but
no spark or flame. (Remote is
locked out).
Battery holder (including switch)
or remote has low battery.
Error with synchronizing.
Remote too far away from
battery holder (including switch).
Door is open.
No power to the system.
Battery holder (including switch)
in wrong position (if equipped).
Battery holder, battery holder
(including switch) and/or remote
control isn't operational.
High limit switch has tripped.
test solution
Remove blockage. In really cold conditions, ice buildup may
-
occur on the terminal and should be removed as required.
Clean the glass with a recommended gas fireplace glass
-
cleaner. DO NOT CLEAN GLASS WHEN HOT.
- If sulphur deposits are not cleaned off regularly, the glass may
become permanently marked.
Check firebox glass door was properly reinstalled after cleaning.
-
If not recti fi ed, turn off appliance. Contact a qualified technician.
Reprogram receiver code.
-
Replace battery holder (including switch), if applicable.
-
Contact a qualified technician.
-
Fill the tank.
-
Follow reprogramming instructions for specific remote
-
installed with your appliance.
Replace remote control.
-
Reverse.
-
Replace.
-
Check for ground (short); repair ground or replace wire.
-
Replace.
-
Reset by turning power source off then on.
-
note:
If back up batteries are installed, they must also be
removed to re-program
Replace batteries.
-
Reset battery holder (including switch) and remote control.
-
-
Refer to "wiring diagram" section in the Installation manual.
Ensure door is secured properly. If not rectified, contact a
-
qualified technician.
Check breaker to verify it's in the "on" position.
-
Verify that the 3 position switch on the battery holder (including
-
switch) is in the remote position (middle).
-
Check battery power and battery orientation.
Your appliance (LV models equipped with DHC or LVX models)
-
is fitted with a safety switch that shuts your appliance off in the
event that your fireplace and/or enclosure are reaching unsafe
operating temperatures. Contact a qualified technician.