Napoleon Luxuria LVX38P2-1 Manuel Du Propriétaire page 29

Recheck if the outer glass of the GGA-1 is touching the heat rail gasket on both ends.
14.
Check for any excessive play by lightly pulling the GGA-1 outwards. The play (rattle / movement) should
15.
be negligible in the system when the GGA-1 is held in position by the latches.
If there is excessive play, the GGA-1 catches on the bottom of the GGA-1 should be adjusted forward to
16.
reduce the play to a minimal amount. This is to ensure GGA-1 can still be secured and released smoothly
without excessive force (Fig. 20).
note:
The GGA-1 should slide smoothly back and latch with a 'click'. Front to back play should be negligible. The
GGA-1 should unlatch smoothly without the need for excessive force. Continue to adjust the GGA-1 catches
and/or latches until the GGA-1 can be moved correctly. Tighten all screws securely but do not overtighten.
Remove GGA-1 (see, "to remove GGA-1" section) and safely store the GGA-1 after preliminary
17.
adjustment. Ensure GGA-1 is placed on a non-abrasive material to avoid scratches. It is recommended
to store the GGA-1 in the original packaging taking care to ensure glass surfaces are protected from
scratches.
Re-install GGA-1 after the appliance finishing then re-check alignment.
18.
Secure GGA-1 by tightening the GGA-1 slider bracket screws on both ends securely.
19.
For see-thru models, repeat instructions for second GGA-1 to be installed on the fixed side.
GGA-1 catch GGA-1 catch
securing screws
maintenance
Outer glass
Fig. 20
W415-2036 / E / 05.10.22
EN
29