Napoleon Luxuria LVX38P2-1 Manuel Du Propriétaire page 26

maintenance
EN
Secure GGA-1 with 1 fastener and 1 washer on top and bottom of each GGA-1 slider bracket (total of 4)
9.
holding the GGA-1 tight to the GGA-1 slider bracket surface throughout (Fig. 12). Tighten firmly enough
to hold GGA-1 against GGA-1 slider bracket. Do not fully tighten until adjustment is complete and during
final GGA-1 installation.
The GGA-1 catches should be installed toward the appliance. It may be necessary to loosen the GGA-1
10.
catch securing screws on the bottom of both sides of the GGA-1 and slide them all the way towards the
back of the GGA-1. Retighten securing screws (Fig. 13).
26
W415-2036 / E / 05.10.22
GGA-1 catch GGA-1 catch
securing screws
Fig. 12
Outer glass
Fig. 13