XYZ Printing da Vinci Color AiO Manuel De L'utilisateur page 9

Function Operation and Instructions
A3 Filament Refill Material
Color AiO will prompt you to refill material.
1. Tap the icon when printing.
5. Replace the empty spool with a new one. (please refer to the
LOADING section in this manual) and then tap "PROCEED" .
7. The filament will be
automatically loaded.
B. USB printing
1. Check if the USB drive is
plugged to the machine.
5. The screen will show the
print percentage when printing.
The Pause, Stop, and Refill
are shown below the print
percentage.
B1 Unload the prints
Please removed the EZ Removable Rubber Magnet with printed object together from the printer.And
peel off the printed object from the rubber magnet.
2. The screen will show filament
status, please tap "Refill" .
8. Check if filament is extruded from the nozzle, after confirmation,
the printer will resume printing.
2. Tap the USB Printing Menu in
the main screen.
Note
By default, the front door will be
locked when printing. If you want to
change this setting, go to Setting >
Door Lock to change it.
3. Confirm the operation.
6. The nozzle will be preheat and notify you when to insert filament
into the feed module.
3. Select the file you want to
print.
4. The nozzle will be preheated
and the filament will be
unloaded automatically.
4. Check file information and
tap "Print".
Please avoid touch-
ing the led strip of the
printer because the
LED strip will be slight
hot due to long hours
of been light on.
P9 P9