Function Operation And Instructions - XYZ Printing da Vinci Color AiO Manuel De L'utilisateur

Function Operation and Instructions

A. Load/unload filaments
A1 Filament Load filaments
1. Please cut the filament at 45
angle before auto loading the
filament into the printer. During
loading filament process, the
filament should be straighten at
least 4" of the Filament end as
shown in pictures.
5. Tap Load.
8. Check if the temperature of the print head goes up to its operating temperature (Color PLA from
XYZprinting) after the filament is loaded. Once the set temperature is reached, the feeding motor will
feed the filament along the guide tube into the print head.
A2 Filament Unloading filaments
1. Tap Filament Load and
Unload on the main screen.
5. When the unloading
operation completes, tap to
confirm.
2. Place the filament on the
spool holder.
Make sure the filament rotates
Note
clockwise when pulled.
6. Confirm the operation.
2. Tap "Unload" and confirm the
operation.
3. Tap Filament Load and
Unload in the main screen and
select Filament.
7. Insert the filament into the feed module, it will be automatically loaded.
3. Confirm the unloading
operation.
4. Tap Filament.
9. Once filament has extruded
from the print head, the filament
will be successfully loaded.
Tap the screen to confirm and
continue.
4. When the print head has
been warmed up to 220 °C,
the feeding motor will eject the
filament.
P8 P8