Air Circulation; Adjusting The Timer - Inventum AC125W Mode D'emploi

Caution:
• Condensation water may run out of the drain when the screw cap
is removed and the appliance has been used in cooling mode.
Keep a drip tray at hand when removing the screw cap, in order
to collect the condensation water.
• Make sure the discharge hose for the condensation water properly
descends and is not higher than the drain of the appliance.
• When using the cooling position, it is recommended to not
discharge the condensation water continuously, but to close
the screw cap again. In this way the appliance is able to provide
its best performance.

AIR CIRCULATION

When using this position, the air discharge hose does not have to be connected.
• Press the [ mode /
• Press the [ speed /
This is indicated on the display as follows:
AUTOMATIC POSITION
When using the automatic position, the appliance automatically selects whether it should cool or circulate air. This depends
on the room temperature.
• Press the [ mode /
• It is possible to adjust the wind speed. Press the [ speed /
When the room temperature is below 23°C, the appliance starts to circulate the air, and above 23°C the appliance starts to cool.

ADJUSTING THE TIMER -

The timer function can be used to allow the appliance to switch on automatically (delayed start) or switch off automatically
at a set time (automatic deactivation).
Delayed start
• Switch on the appliance and select the position you want to use.
• Switch off the appliance. The appliance remembers the last setting and will switch on at that position/temperature.
• Press the timer key
on by means of the [ temp
The delayed start can be set per 30 minutes between 0 and 24 hours.
• Wait 5 seconds until the timer is confirmed. The indicator light of the timer lights up and
• When the set number of hours have passed, the appliance switches on automatically.
To cancel the delayed start, press the timer key once more or press the ON/OFF key.
Automatic deactivation
• Press the timer key
off by means of the [ temp
The automatic deactivation can be set per 30 minutes between 0 and 24 hours.
• Wait 5 seconds until the timer is confirmed. The indicator light of the timer lights up and the time is shown in the display.
• When the set number of hours have passed, the appliance switches off automatically.
] key until the indicator light - air circulation - lights up.
] key to set the wind speed to - high
high speed,
] key until the indicator light - auto - lights up. The display shows the following:
when the appliance is off and select the required time at which you want the appliance to switch
and temp ] keys.
when the appliance is on and select the required time at which you want the appliance to switch
and temp ] keys.
, medium or low -.
medium speed, low speed.
] key to select the required wind speed.
is shown in the display.
English •
27