Tips For Efficient Use; Draining Condensation Water - Inventum AC125W Mode D'emploi

CHANGING THE TEMPERATURE UNIT CELSIUS / FAHRENHEIT
Press the °C/°F key when the appliance is stand-by to change the display of the temperature unit.
Example: if the appliance is on COOLING 24°C, the display shows 24 as indicated to the right.
When you switch on the appliance again after changing the temperature unit, the display
shows 75.
5

tips for efficient use

For a maximum performance of the appliance, observe the following recommendations:
• Close the windows and doors of the rooms to be cooled. If you want to leave the appliance
in a room, we recommend leaving the door slightly open ( 1 cm ) so that a good ventilation can
be provided.
• Close curtains and/or blinds to keep out the sun, so that the appliance does not have to cool
as much and consumes less energy.
• Do not place anything on top of the appliance.
• Do not cover the air inlets and outlets. Make sure all grilles are uncovered.
• Ensure there are no heat sources in the room.
• Do not use the appliance in very humid rooms, such as bathrooms and laundry rooms.
• Never use the appliance outdoors.
• Make sure the appliance is placed on a flat, stable surface.
6

draining condensation water

When there is excess condensation water in the appliance, the appliance switches off automatically and
display to indicate that the internal water reservoir is full. Excess condensation water can be removed as follows:
Manual discharge - when using the appliance in a room with high air humidity.
1. Remove the plug from the socket.
2. Place a low receptacle under the lower outlet for condensation water
discharge. See the drawing.
3. Remove the screw cap.
4. The water flows out of the drain into the receptacle.
5. Place back the screw cap when no more water is flowing out.
6. Switch the appliance on again.
Continuous discharge - recommended when using the dehumidification
position.
1. Remove the plug from the socket.
2. Remove the screw cap. Keep a drip tray at hand when removing the
screw cap in order to collect the condensation water that may come
out of the outlet.
3. Connect the discharge hose (1/2" or 12.7 mm). See drawing.
4. The water is discharged continuously via the discharge hose.
5. Switch the appliance on again.
Condensation water can also be discharged as described on page 12,
at section DEHUMIDIFICATION.
is shown in the
outlet
screw cap
screw cap
discharge hose
outlet
English
29
•