Yakima 8008121 Mode D'emploi page 2

Remove refl ector.
Using a crosshead
screwdriver remove
the screw that secures
the front refl ector, and
remove the refl ector.
Set both the screw and
refl ector aside.
Install mounting plate.
Place mounting plate onto T-Bolts. Thread
lock nuts onto T-Bolts. Tighten down nuts.
Bolt wheel to mounting bracket.
Insert bolt through lock
washer, large washer, spare
tire, and into mounting bracket.
Tighten down the Spare Tire
using fi rm resistance.
1033551B-2/6
Insert T-Bolts into slot.
Slide both T-Nuts
into slot as shown.
Replace refl ector.
WARNING
Be sure there is no interference between
the Spare Tire and the black lever . If there
is interference you must move the mounting
bracket back until there is no interference.
Replace the refl ector
and replace the screw
using a crosshead
screw driver.