Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
Reprogramming the remote:
Open the control box and locate the dimmer/switch module.
(1) Switch on the main power
(2) Be aware of any exposed wiring
(3) Find the "Learning Key" on the dimmer/switch module
Min.Set
max.
400W
AC 100-240V
L
Register transmitter with the receiver
(1) Press the "Learning Key" for one second. The search mode will be active
for a short period. Use the dim for the light and the switches for the heating.
(2) Send a signal to the receiver with the remote by clicking one of the
buttons on the remote control. If this is first use of the BEEM , please be
sure that the protective film on the battery of the remote is removed.
(3) The receiver will store the applicable transmission code in the receivers
memory. If the device successfully paired with the remote, the light of the
BEEM will light up briefly (1-2 seconds).
Repeat this procedure to register several remotes, if required. The receiver
can store up to eight transmission codes in its memory. The memory will be
retained if you install the receiver somewhere else or if the power goes off.
46
A1-A2: 8-230V
Learning
Key
N
L
N
N
L
Light
H1
H1
Heatzone 1
OFF
ON
H2
H2
Heatzone 2
OFF
ON
Front side
Heatsail BEEM®
Publicité
Table des Matières
