Heatsail BEEM 230 Manuel De L'utilisateur page 45

EN
8. Troubleshooting
The electrical supply must be disconnected via the installation's mains
breaker before any work can be carried out.
The light does not work
You can replace the bulb by carefully lifting up the glass panel and remove
it by turning it. Now you have access to the halogen bulb. Verify it is well
inserted and not broken. If you need to change the bulb replace it with a
standard G9 halogen bulbs of 230V max 40 Watt.
NOTE: Always use a cloth or gloves to replace the bulb, touching it with
hands shortens the life considerably.
If this does not resolve your issue, verify that the brown wires are properly
inserted into the connection block. (step 9 or 16). If problem persists,
reprogram the remote (See next page).
No heat
Check if the BEEM is switched on.
The heating switches give a sound, check if you hear a click when you
press H1 and H2. If this is not the case, the switch does not get power or is
broken. Check if all wires are connected properly. (step 9 or 16)
Only some elements are heating
If elements are not working verify that the black and blue and gray and
blue wires are securely connected in the proper terminals. (Step 9 or 16)
Nothing works
Verify all wires are properly inserted in the connector block. (Step 9 or 16).
Verify that the circuit breaker switch is not tripped/is turned on.
User manual 45