Heatsail BEEM 230 Manuel De L'utilisateur page 30

EN
To reduce the risk of fire, keep textiles, curtains, or any other flammable
material a minimum distance of 100 cm (40 inches) from the BEEM. Never
cover your BEEM without disconnect the power supply via the main switch.
The BEEM must never be touched with bare, wet or damp body parts.
The BEEM is constructed of 6 (BEEM 230, BEEM 290) or 8 (BEEM 390,
BEEM 520) high radiance ceramic heating elements, mounted on a
reflective plate. The full operating temperature will be reached within 30
minutes.
Please note: There is no noticeable glow in the infrared area.
Never use the BEEM to light anything on fire. The ceramic elements are
fragile and must be handled with care. The same also applies to the glass
casing.
The BEEM can only be installed at covered places.
The BEEM is not allowed for use in greenhouses or construction sites.
Always keep the BEEM free of snow.
Heatsail will not be held responsible for damage resulting from
non-compliance with the instructions regarding use and maintenance.
3. Maintenance
3.1 Cleaning
Your BEEM must be cleaned on a monthly basis.
The electrical supply must be disconnected via the installation's breaker
switch before cleaning activities can commence. Cleaning may only be
done with a dry and soft cloth. Do not use any abrasive cloths. Do not
use detergents. Using a high pressure and/or steam cleaner is prohibited.
Cleaning is only permitted once the BEEM has completely cooled down.
Non-compliance with these rules may compromise the safety of the de-
vice. Heatsail will not be held responsible for damage resulting from
non-compliance with the cleaning instructions.
30 Heatsail BEEM®