Installing The Gps Aerial; Installation Notes; Parts Supplied - Pioneer AVIC-F20BT Manuel D'installation

Masquer les pouces Voir aussi pour AVIC-F20BT:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 88
Installation

Installing the GPS aerial

CAUTION
Do not cut the GPS aerial lead to shorten it
or use an extension to make it longer. Alter-
ing the aerial cable could result in a short cir-
cuit or malfunction and permanent damage
to the navigation system.

Installation notes

! The aerial should be installed on a level sur-
face where radio waves will be blocked as
little as possible. Radio waves cannot be re-
ceived by the aerial if reception from the sa-
tellite is blocked.
Dashboard
! When installing the GPS aerial inside the
vehicle, be sure to use the metal sheet pro-
vided with your system. If this is not used,
the reception sensitivity will be poor.
! Do not cut the accessory metal sheet. This
would reduce the sensitivity of the GPS aer-
ial.
! Take care not to pull the aerial lead when
removing the GPS aerial. The magnet at-
tached to the aerial is very powerful, and
the lead may become detached.
! Do not paint the GPS aerial, as this may af-
fect its performance.

Parts supplied

Rear shelf
GPS aerial
Section
04
Metal sheet
25
Engb

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Avic-f920bt

Table des Matières