hestan GABR CX2 Serie Manuel D'utilisation Et D'entretien page 16

GAS CONNECTIONS
GAS CONNECTION - NATURAL GAS (NG)
NOTE: To ensure proper heating performance of this appliance, verify that the gas line supply NOTE:
pressure is adequate. Use only the gas pressure regulator supplied with this appliance. This
EN
regulator is set for a supply (inlet) pressure of 7-14 inch WC [1.74-3.48 kPa] to maintain 4 inch WC
[1.00 kPa] nominal outlet (manifold) pressure. Use the supplied 10 ft [3 m] gas hose to prevent
gas starvation. Ensure that the service pipe supplying the appliance is fitted with a shut-off valve
conveniently positioned and easily accessible as an emergency gas shut-off.
Your Hestan Deluxe Grill for use with Natural Gas is supplied with its own regulator which is
pre-installed inside the unit. If this regulator needs to be replaced, use only the type specified by
Hestan for this appliance. The 10 ft. [3 m] long hose is also pre-installed at the factory. Locate your
gas connection point near the rear of your grill. The hose as well as the connectors must comply
with the Standard for Connectors for Outdoor Gas Appliances and Manufactured Homes, ANSI
Z21.75 • CSA 6.27 , and suitable for outdoor installation. Use the appropriate thread sealant on all
connections.
It is assumed you have a stationary incoming gas supply located near the rear of the unit, with a
shutoff valve pre-installed (see above image). To connect the hose assembly follow the next steps:
1. Remove the quick-disconnect coupling of the hose by sliding back the black sleeve. Install
this brass section onto the shutoff valve with appropriate thread sealent. See instruction tag
supplied with the hose for more detail.
2. Re-connect the coupling of the hose. Open the shutoff valve.
3. Proceed to LEAK TESTING section.
14
©2021 Hestan Commercial Corporation
(continued)
HESTAN DELUXE GRILL
10 ft FLEX HOSE w/
QUICK DISCONNECT
SHUTOFF VALVE
(SUPPLIED BY CUSTOMER)
INCOMING
NAT GAS SUPPLY