KIRAMI Tubtainer 2 Instructions D'utilisation page 46

© Kirami Oy, Finland
NO Meaning
0 Wanted water temperature
1 Heater protection temperature
Automatic restart
0 = will remain in standy after
2 power reconnection
1 = will continue in same mode
as before power outage
Pump mode
0 = Pump will run always when
turned on or via timer. Not
3
depending on the heat need.
1 = Pump stops whenever heat is
not needed.
Water temperature difference to
4
restart
Maximum water inlet
5 temperature
setting value
Maximum water outlet
6 temperature
setting value
7 Water inlet temperature
8 Temperature of the heater
9 Water outlet temperature
A Ambient temperature
NOTICE! Parameter number 3 affects considerably to running hours of the pump. If heating is
needed a lot (more than four hours / day) it makes sense to have this setting as 1. So that the pump only runs
when heating is needed. If there is low need for heating. Then you need to consider the minimum filter
cycles / day. This can be reached with the times. The water volume of the pool should be circulated at least
twice / day. And the filter should also run at least one hour / day.
Tubtainer 2 heater/filter system
46/108
Range
15~43°C
95 ~ 110°C
0/1
0/1
1 ~ 10°C
15 ~ 43°C
~ 50°C
-9 ~ 99°C
-9 ~ 99°C
-9 ~ 99°C
-9 ~ 99°C
Table 1 – Device parameters
22.12.2020
Change Factory setting
YES
YES 95°C
YES
YES
YES
YES
YES
Measured value
Measured value
Measured value
Measured value
27
1
0
2
43
50
P 10/17
AGE