Install The Hood - CIARRA 736N Manuel De L'utilisateur Et D'installation

Installation
Install the Hood（VENT OUTSIDE）:
1) If present, remove all protective poly film from the hood and/or parts.
2) Below is the 1:1 hole drilling installation drawing:
EN
3) According to the 1:1 hole drawing, Drill 3*Ø8mm holes to accommodate
the bracket. Screw and tighten the bracket onto the wall with the screws &
screw plugs provided.
Attention:
Observe the warning in the instruction sheet concerning the
operation of the appliance when air is discharged from the room.
When the range hood and appliance supplied with energy other than electricity
are simultaneously in operation, the negative pressure in the room must be not
exceed 4 Pa (4×10 Bar).
-5
8