Electrical Connection - Fein GRIT GI1502H5V6 Manuel D'utilisation

GI 75 (US).book Seite 16 Dienstag, 4. November 2008 10:39 10
en

13. Electrical connection.

Hazardous Voltage
WARNING
Contact may cause electric shock or burn.
When wiring this machine make sure it is properly grounded in accordance with National
Electric code and local codes and ordinances. This work should be done by a qualified electrician.
This machine should be grounded while in use to protect the operator from electrical shock. The
tool is equipped with an approved three-conductor cord three-prong grounding type plug to fit the
proper grounding type receptacle. The green (or green and yellow) conductor in the cord is the
grounding wire. Never connect the green (or green and yellow) wire to a liive terminal. If your unit
is a 220/440 V 3-phase system, the connection to the power source should be done by a four wire
cable as shown in figure. When making the connections, check the motor for proper rotation. To
change the motor rotation, switch two of the live leads. The green wire is always the ground wire
and is never to be connected to a live terminal. This work should be done by a qualified electrician.
16
GI 75