Adjusting The Grinding Rest (Figure 3); Adjusting The Stop (Figure 4); Adjusting The Face- Grinding Rest; Adjusting The Belt Tracking - Fein GRIT GI1502H5V6 Manuel D'utilisation

GI 75 (US).book Seite 11 Dienstag, 4. November 2008 10:39 10
GI 75

7.2 Adjusting the grinding rest (Figure 3).

The gap size must always be
WARNING
adjusted to the correct size. Thin
workpieces could be pulled into the machine
and cause severe or fatal injury.
Loosen star-knob bolt and adjust the gap
size to 2 mm (max.).
Tighten the star-knob bolt again.

7.3 Adjusting the stop (Figure 4).

Loosen the screws and adjust the gap size.
The gap size must not exceed 2 mm (max.)!
Tighten screws again.

7.4 Adjusting the face- grinding rest.

The gap size must always be
WARNING
adjusted to the correct size. Thin
workpieces could be pulled into the machine
and cause severe or fatal injury.
For face grinding applications, the face- grinding
rest must be aligned parallel to the grinding belt
and must touch it over the complete surface.

7.5 Adjusting the belt tracking.

Switch the machine on only
briefly and check the belt track-
ing.
If the grinding belt moves left or
right, adjust the belt tracking
with the star-knob bolt until centred.
If the belt tracking cannot be adjusted centred:
Clean the drive wheel and the contact
wheel with compressed air.
Star-knob bolt
for grinding rest
max 2 mm
Star-knob bolt
for grinding rest
Loosen screw and fold the side cover down.
Loosen screws and align the face-grinding
rest. Tighten the screw again.
Shut the side cover and tighten screw again.
Check the gap size at the stop.
Check the drive wheel and the contact
wheel for wear, deformation and damage.
Have damaged components replaced with-
out delay!
en
Fig. 3
WARNING
max 2 mm
Fig. 4
WARNING
11