Changing The Grinding Belt (Figures 1 + 2); Operating Instructions; Switching On: (Figure 5); Switching Off: (Figure 5) - Fein GRIT GI1502H5V6 Manuel D'utilisation

GI 75 (US).book Seite 12 Dienstag, 4. November 2008 10:39 10
en

8. Changing the grinding belt (Figures 1 + 2).

Before any work on the machine
WARNING
itself, pull the power plug from
the socket outlet.
Loosen screw and fold the side cover down.
Loosen star-knob bolt and remove the dust
collector.
Push belt tension lever down
to release the clamping device.
Remove the old grinding belt.
Before attaching the new grinding belt,
observe the information concerning the run-
ning direction on the inner side of the grind-
ing belt! It must correspond with the running
direction of the drive wheel.

9. Operating instructions.

Never touch the running grinding belt. Danger of injury.
CAUTION
Always use safety glasses. Also use face or
dust mask if cutting operation is dusty. Eve-
ryday eyeglasses only have impact resistant
lenses, they are NOT safety glasses.
Wear appropriate safety clothing. Wear
leather safety gloves, arm guards, leather
aprons and safety shoes. Wear dust mask
and ear protection.
Wear safety glasses.

9.1 Switching ON: (Figure 5)

Release the emergency OFF pushbutton and
lift it up. Press the "I" button.

9.2 Switching OFF: (Figure 5)

Lift up the emergency OFF pushbutton.
Press the "0" button.
After switching off, the machine runs on
for approx. 50 seconds.
12
Place the grinding belt both around the drive
wheel and around the contact wheel.
Push the belt tension lever up
again to tension the grinding
belt.
If the grinding belt cannot be tensioned suf-
ficiently, the clamping device must be read-
justed. Loosen both screws, move the
clamping device and tighten the screws
again.
Shut the side cover and tighten screw again.
Remount the dust collector and check the
gap size at the grinding rest.
Switch the machine on and adjust the belt
run.
Present the workpiece to the abrasive belt below
the horizontal centerline of the contact wheel.
Above the centerline, the workpiece will chatter
and it is diffficult to hold, with the possibility the
work piece could be pulled away.
Always use an upward stroke to present the work
piece to the abrasive belt. This method both
improves the cuting and increases safety by
drawing hands away from the abrasive belt.
GI 75