Rexel Auto+ 80X Manuel D'utilisation page 6

Autofeed Technology
The Auto+ 80X has been designed to automatically shred up
to 80 sheets from the autofeed chamber and up to 6 sheets
through the manual feed slot. The auto-feed mechanism has
been designed to handle paper fastened with staples and paper
clips and to only pull a few sheets of paper into the cutting
mechanism to minimise the risk of paper jams.
Operation
Unpack the product.
1
Connect the shredder to mains supply.
2
Ensure the ON/OFF switch on the back of the shredder is in
3
the "ON" position, which will illuminate the LED bulb by the
standby symbol ( ).
To commence shredding, move the slide switch to the Auto
4
position ( ) which sets the shredder into auto mode. You
are now ready to shred.
To load the shredder, simply lift the loading door handle
5
(see fig 1) to open the loading door and insert documents.
You can open the door further to 90 degrees for easier
access if required. Load up to 80 sheets at a time into the
feed chamber. Do not fill above the MAX level, as this could
damage the shredder (see fig 2).
The shredder will start the shredding cycle automatically
6
ONLY after closing the loading door (see fig 1).
If you only have up to 6 sheets to shred, you can use the
7
manual feed slot, provided the auto feed chamber is empty
(see fig 3).
Bin or Loading Door Open Safety
Function
As a safety precaution, if the bin or loading door is opened
during shredding, the shredder will stop and the Bin Full
indicator will illuminate.
Rare Occasions of Jamming
In the unlikely event of the shredder jamming, the Auto+ 80X
will stop shredding. Check that the bin is not full then try
clearing the jam using the reverse (
boost ( ) buttons then return to Auto mode (
unsuccessful follow the reverse function instructions.
6
Reverse Function
1
2
3
Over Heating
If the Auto+ 80X is used continuously for over 10 minutes the
shredder may overheat and the red cool down indicator will
illuminate underneath the thermometer symbol (
allow the shredder to cool down. When the shredder is ready
to be used the thermometer symbol will no longer illuminate. If
the shredder needs to cool down while shredding, no action is
needed. The shredder will automatically restart shredding paper
once it has cooled down after periods of continuous use. All you
need to do is ensure paper is loaded into the chamber and the
bin is empty when the machine is cooling down.
Credit Card Shredding
The Auto+ 80X can shred credit cards. Switch the shredder to
auto mode and insert the credit card between the markings in
the manual feed slot (see fig. 4). Only shred one credit card at
a time.
Rexel encourages customers to recycle shredded paper.
Please note that shredded paper cannot be recycled
if mixed with credit card shards. If recycling, please
separate shredded paper and credit cards.
Bin Full
The shredder will not function when the bin is full and the bin
full symbol (
• Pull open the bin slowly to empty.
) and continuous jam
• Push the empty bin back into place and the machine will
). If this is
resume shredding.
Should you wish to reverse paper out whilst shredding, a
reverse button ( ) has been fitted for your convenience.
Reverse the paper out then turn the shredder off using the
ON/OFF switch at the rear of the shredder. Remove the
paper from the manual feed slot (if being used) or open the
loading door, remove the remaining stack of paper, then pull
the jammed paper free of the cutting mechanism.
To resume shredding return the slide switch to the auto
position ( ) and turn on the machine by using the ON/OFF
switch at the rear of the shredder.
) is illuminated. You should empty the bin.
). Please