Segment Control; Light Intensity Setting - SCHOTT VisiLED Serie Conseils D'utilisation

8.2 Segment control

8.3 Light intensity setting

50 | VisiLED-Serie
All VisiLED illuminations can be controlled in segments using the MC 1500.
By choosing the optimal segment mode for each specimen an object contrast-
ing can be achieved which far exceeds the contrasts one gets using a non-
segmented ringlight.
Repeated activation of the select key (3) changes the segment mode of the
selected illumination unit (A or B):
"Full circle Semi-circle
4 segment mode Full circle
The LED indicators of the segment control (2) display in which segment mode
the selected unit is currently set.
To change or check the segment mode of the second VisiLED unit this must
first be selected using the unit selector key (1).
If the MC 1500 is being controlled via a computer then all 8 individual seg-
ments of each illumination unit can be accessed. By combining the individual
segments user-defined segment modes can be set.
The MC 1500 makes it possible to set the brightness of all VisiLED illumi-
nations.
By pressing key (5) the brightness of the selected LED illumination unit
(A or B) can be set. Short tapping increases or decreases the brightness in
small steps. Continuous pressing of (5) increases (or decreases) the brightness
steplessly.
The LED indicators of the brightness setting (4) display in which brightness
range the selected illumination unit currently is:
Range LED indicator display (4)
1 No LED lit
2 One green LED
3 Two green LEDs
4 Two green and one yellow LED
5 – "Overdrive" Two green, one yellow
and one red LED
Quarter-circle 2 segment mode
...."
Light intensity of selected
LED illumination
0%
2%
33%
60 %
83%
to 1%
to 32%
to 59 %
to 82%
to 100%