System Set-Up; Start-Up Procedure - SCHOTT VisiLED Serie Conseils D'utilisation

4. System set-up

5. Start-up procedure

46 | VisiLED-Serie
The system should only be set up when the LED controller is switched off
(on/off switch [17] in position ) and with mains plug disconnected.
Please take care that the VisiLED system is used with electronic power supplies
and power cords specified by SCHOTT and that the power supply is only
operated with the specified mains voltage.
To operate the MC 750 and MC 1000 first attach the LED illumination unit to
the controller connection (11). Please fix the connected plug using the two
fastening screws. Then connect the electronic power supply with connector
(16). Finally connect the power cord to the power socket (for permitted power
voltage see Section 12, Technical data).
The MC 1500 memory controller allows the connection of up to two VisiLED il-
lumination units. Please connect the unit(s) with connectors (11) or/and (12)
of the controller. Fix the connected plug using the two fastening screws.
If connection to a PC is required please attach the RS232 cable provided or the
USB 1.1-to-R232-converter (accessory) to the MC 1500 controller connection
and fix with the fastening screws. Connect the other side of the RS232 cable or
converter to a free RS232 or USB interface in accordance with the instructions
for your computer.
To install the user software for the MC 1500 please follow the installation
instructions on the supplied CD-ROM.
If required, connect the foot switch (accessory) to the MC 1500.
Finally connect the electronic power supply with connection (16) of the MC
1500 and the 3-pin power cord with the input side of the electronic power
supply.
When the system configuration has been set up connect the mains cable to
the specified mains voltage (see Section 12, Technical data).
The system is switched on/off by operating the ON/OFF switch (17).
Position : The VisiLED controller is switched off.
Position : The VisiLED controller is switched on.
The output voltage of the electronic power supply is stabilized. This ensures
stable light performance, irrespective of power fluctuations. The LED light
produced is ripple-free.