Warn 86386 Instructions D'installation page 10

16. The next step is to mount the winch now
that all hardware is tight. The winch may be
installed through the side of the bumper, then
lowered on to the winch mount. Fasten the
winch at this time. See figure 21.
Note: Make sure to remove the long screw that
is located under the winch drum if winch is
new.
17. Attach the new bumper cover that comes in the
kit to replace the old fascia using the previously
removed M6 bolts. Also attach the strap to the
bumper tube, this will be what the winch hook
will attach to when using the plow. See figure
22.
WARN® INDUSTRIES PAGE 10
Figure 20
Figure 21
Figure 22
86388A0