Panasonic AW-PH400E Mode D'emploi page 36

Pan/Tilt Control Panel AW-RP400
Parts and their function
% REMOTE connector
Connect an external unit to this connector to control the
pan-tilt head systems from a PC or other external unit.
Connect the connector to the PC using the RS-232C
cable (AW-CA50T9).
& DC 12V IN socket
Connect the AC adapter (AW-PS505A, sold separately)
to this socket.
' CONTROL OUT TO PAN/TILT HEAD [P1] to [P5]
connectors
Connect these connectors to the IP/RP connectors on the
indoor pan/tilt heads (AW-PH400) using 10BASE-T
(equivalent to UTP category 5) straight cables. The
cables can be extended up to a maximum of 500 meters.
( MONI SEL OUT connector
Connect this connector to the MONI SEL OUT connector
on the cable compensation unit (AW-RC400) using a
10BASE-T (equivalent to UTP category 5) straight cable.
You can monitor the images of the system selected
by the AW-RP400 from the MONITOR1 connector on
the AW-RC400 and the images of the system selected
by the remote operation panel (AW-CB400) from the
MONITOR2 connector on the AW-RC400.
If two AW-RP400 units are connected, you can monitor the
images of the system selected by the master AW-RP400
from the MONITOR1 connector on the AW-RC400 and the
images of the system selected by the slave AW-RP400
from the MONITOR2 connector on the AW-RC400.
) CAMERA CONTROL IN FROM ROP connector
Connect the remote operation panel (AW-CB400) to this
connector using the connecting cable packed with the
AW-CB400.
The cameras installed on the pan-tilt heads can now be
controlled from the AW-CB400.
* Ground terminal
Connect this terminal to ground.
35 (E)