Panasonic AW-PH400E Mode D'emploi page 11

Parts and their function
 Guide pin
Use this to determine the direction in which the camera is
to be mounted.
 Camera mounting screws (U1/4-20UNC)
These are used to secure the camera firmly after it has
been mounted.
 Side blank panel
This is used when the mounting direction of the pedestal
connector panel is to be changed.
 SDI IN connector [SDI IN]
Use a coaxial cable to connect this to the SDI OUT
connector on the SDI card (AW-PB504) or other card
installed in the convertible camera.
 LENS I/F (2) connector [LENS I/F (2)]
The current rating of the LENS I/F (2) connector is
500 mA.
The lens whose maximum current consumption exceeds
500 mA cannot be used. Concerning the maximum
current consumption of the lens, contact the lens
manufacturer. This is used when an IAS, WAS or VAS
lens made by Canon or an RD lens made by Fujinon is to
be used.
The optional connecting cable is required to connect the
lens with the connector.
Lens
Canon
Digital AW-CA4DLZG
Analogue AW-CA4ALZG
Fujinon AW-CA4FLZG
Note
Refer to the instructions for using the connecting cable
to ensure that it is connected properly.
 OPTION connector [OPTION]
The optional roll unit (AW-RL400) is connected here
using the cable supplied with the AW-RL400.
 LENS I/F (1) connector [LENS I/F (1)]
This is used to control the zooming and focusing of the
motorized lens unit. Use the motorized lens unit's remote
(zoom/focus) control cable to make the connection.
 CAMERA I/F connector [CAMERA I/F]
This is used for the control of the convertible camera.
Use the camera cable supplied with the unit (AW-PH400)
to connect the connector with the REMOTE connector on
the camera. Depending on the functions of the optional
card, a special camera cable (sold separately) is required.
Cable
10 (E)
Indoor Pan/Tilt Head AW-PH400
 ND/EXT connector [ND/EXT]
This is for the control of the ND filter and lens extender of
the motorized lens unit.
Connect this connector when using a motorized lens unit
with ND filter and lens extender functions.
The compatible connector is the R03-P6M or R03-PB6M
made by Tajimi Electronics Co., Ltd.
ND signal
ND return
EXT signal
(Pin layout as seen from cable end)
 TALLY ON/OFF switch [TALLY]
When this is set to ON, the tally lamp is lit by the selected
signals. When it is set to OFF, the ( ) tally lamp will not
light even if the selected signals are supplied.
CONTROL IN IP/RP connector [IP/RP]
This is the connector for the control of signals of the
camera and pan-tilt head.
It is connected to the CONTROL OUT TO PAN/TILT
connector on the pan/tilt control panel (AW-RP400).
Use a 10BASE-T straight cable (equivalent to UTP
category 5) for the connecting cable.
VIDEO connector [VIDEO]
This is the output connector for the camera's video
signals. It is connected to the Y/VIDEO connector on the
cable compensation unit (AW-RC400) or monitor, etc.
Use a BNC coaxial cable for the connecting cable.
CABLE COMP ON/OFF switch [CABLE COMP]
When this is set to ON, signals which have been cable-
compensated for the equivalent of 500 meters are
output from the VIDEO connector and the Y, Pr and Pb
connectors.
When this switch is used in conjunction with the
cable compensation unit (AW-RC400), the video cable
can be extended up to a maximum of 1000 meters.
CVCC (+12V)
CGND
EXT return