Panasonic AW-PH400E Mode D'emploi page 24

Indoor Pan/Tilt Head AW-PH400
Installation
w Mounting the camera
[Multi Purpose Camera (AK-HC1500G/AK-HC1800G)]
When mounting the camera, take sufficient care to ensure that the camera will not come off or fall down.
Mount the lens onto the multi purpose camera.
(1) Lenses that can be used
• Use any of the portable lenses which are listed below.
Fujinon
Canon
(2) Lenses that cannot be used
• Do not use the large-sized lenses [with a mass (weight) of 5 kg or more
and a length of 400 mm or more] with the model numbers which are
listed below since when they are mounted on the camera, the camera's
overall balance will be upset.
Fujinon
Canon
Align the multi purpose camera with the guide pins and mount it.
Change the positions of the guide pins and screws of the camera mounting base as shown in the figure below, and then
attach the camera mounting base to the rotary arm.
For a stand-alone installation
Camera mounting base
Change the positions of the camera mounting
screws. (Change them over to the second row.)
p Tighten up the 2 mounting screws securely using the
flathead screwdriver.
For installation on the ceiling
Camera mounting base
Change the positions of the camera mounting
screws. (Change them over to the third row.)
p Just as for a convertible camera, change the positions of
the guide pins and screws of the camera mounting base
as shown in the figure above, and then attach the camera
mounting base to the rotary arm.
(Be sure to ask your dealer to install the unit.)
HA18, HA21, HA22 series
HJ17e, HJ21e series
HA42 series
HJ40 series
Change the positions
of the guide pins.
Change the positions
of the guide pins.
Notes
p Use the lens fixing ring knob to tighten
the lens securely, and check for play.
Check the hood for play as well.
p The current rating of LENS I/F (2)
connector is 500 mA (max).
Even with the lenses in a series which
can be used, any lens whose maximum
current consumption exceeds 500 mA
cannot be used.
Concerning the maximum current
consumption of the lens, contact the lens
manufacturer.
Set the guide pin.
Mount the camera
with the mounting
screws.
Mounting screws
Attaching the guide pins
and camera
Guide pins (M4)
Mounting screws (Inch thread)
23 (E)
Lens fixing ring knob
Set the guide pin.
Mount the camera with
the mounting screws.
Mounting screws
Clamping torque
1.5 N m (15 kgf cm)
• •
2.0 N m (20 kgf cm)
• •