To Prevent Damage - Philips Lumea BRI864 Mode D'emploi

12
English

To prevent damage

22_100_5515_2_DFU-Luxury_A6_v3.indd 12
-
The adapter contains a transformer. Do not cut
off the adapter to replace it with another plug,
as this causes a hazardous situation.
-
Do not use the device if the UV filter of the light
exit window is broken.
-
The adapter cord is always attached to device.
Don't try to separate the adapter from the
device. This might damage the cord.
-
Do not use any pencil or pen to mark the areas
to be treated. This may cause burns on your skin.
-
If you have a dark colored skin, be careful
with treating a darker area immediately after
a lighter area. The skin tone sensor may not
block immediately the treatment on the darker
body area.
-
Hair removal by lasers or intense pulse light
sources can cause increased hair growth
in some individuals. Based upon currently
available data, the highest risk groups for this
response are females of Mediterranean, Middle
Eastern and South Asian heritage treated on the
face and neck.
-
Light exit window can become very hot after
usage. Do not touch the inner part of the light
exit window.
Note: Perform a skin test if you notice a skin tone
change from last treatment and wait 30 minutes
before treatment.
-
Make sure that nothing obstructs the air flow
through the ventilation slots.
-
Never subject the appliance to heavy shocks
and do not shake or drop it.
-
If you take the appliance from a very cold
environment to a very warm environment or
vice versa, wait approximately 3 hours before
you use it.
23/06/16 10:15