To Prevent Damage; Electromagnetic Fields (Emf) - Philips SC1992 Mode D'emploi

Masquer les pouces Voir aussi pour SC1992:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 69

To prevent damage

-
Make sure nothing obstructs the air flow through the ventilation slots.
-
Never subject the appliance to heavy shocks and do not shake or drop it.
-
If you take the appliance from a very cold environment to a very warm
environment or vice versa, wait approximately 3 hours before you use it.
-
Store the appliance in the pouch supplied so that it does not become
dusty.
-
Never leave the appliance unattended when it is switched on. Always
switch off the appliance after use.
-
Do not expose the appliance to direct sunlight or UV light for several
hours, to prevent damage.
-
Do not flash against any other surface than the skin. This can cause
severe damage to the body attachment and/or the light exit window.
Only flash when the appliance is in contact with skin.
Caution
-
Never use the appliance around the eyes and near the eyebrows to
avoid the risk of eye damage.
-
Use this appliance only at settings suitable for your skin type (see the
table in section 'Recommended light intensities' of chapter 'Preparing
for use'). Use at higher settings than those recommended can increase
the risk of skin reactions and side effects.
-
This appliance is only intended for removing unwanted human body
hair from areas below the neckline. Do not use it for any other purpose.
-
Make sure the skin in the area to be treated is clean, dry and free from
creams, lotions and other cosmetics. If the skin is not clean and dry, the
integrated safety system may not work as intended and the appliance
may not flash or may flash unintentionally.
Keep the following things in mind to avoid compromising the
lifetime of your Philips Lumea Essential:
-
Do not expose the appliance to ambient temperatures lower than
15°C or higher than 35°C during use.
-
The appliance is equipped with a built-in overheat protection. If the
appliance overheats, it does not flash. Do not switch off the appliance,
but let it cool down for approx. 15 minutes before you continue with
your treatment. After 5 minutes the appliance switches off automatically.
Then let it cool down for another 10 minutes.
-
Always return the appliance to a service centre authorised by Philips
for examination or repair. Repair by unqualified people could cause an
extremely hazardous situation for the user.
-
Do not use the appliance if any of the situations mentioned in section
'Contraindications' apply to you.

Electromagnetic fields (EMF)

This Philips appliance complies with all applicable standards and
regulationsregarding exposure to electromagnetic fields.
ENGLISH
9

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Sc1991

Table des Matières