Saey 92 HOUT Mode D'emploi page 16

3. CONNECTING THE STOVE TO THE CHIMNEY
A strong chimney draught makes it possible to connect the stove directly to the chimney (with outlet at
the back). The diameter of the smoke duct must correspond with that of the connector (150 mm).
When the draught of the chimney is insufficient, under 0,08 mbar (0,8 mm WS) – the stove must be
connected with a perpendicularly smoke duct of 1 till 1,5 m length with the chimney (outlet above).
The smoke duct must be sealed at all connection points! Attention is specifically drawn to the danger of
escaping fumes. False air results in a weaker chimney draught.
If the chimney draught is too strong, the installation of a draught regulator is recommended.
Take note of the following precautionary measures before the smoke duct is installed:
•
The diameter of the smoke duct may not be reduced, the smoke duct may not be made smaller
and it may not be positioned horizontally, but should rise towards the chimney at a slight angle.
•
The stovepipe must fit into the chimney opening to make the discharge of fumes possible. Make
provision for a double lining in this regard.
•
Chimney connections of different stoves may not be positioned opposite one another, i.e. at the
same height. This may obstruct the discharge of exhaust fumes. The minimum distance
between two outlets for fumes should be at least 30 cm.
•
Do not connect too many stoves to one chimney – too many connections hamper the upward
draught. Ask you chimney sweeper for advice.
•
The chimney may not conduct any false air. Ensure that the chimney control valves as well as
the cleaning openings in the cellar are closed.
The smoke duct must be securely attached to the connector
Saey 92 cucina wood :
The discharge of fumes takes place at the back of the stove.
Saey 92 B/A wood :
The discharge of fumes takes
place at the top.
16