Securing The Refrigerator; Gas Installation - Dometic RM 8501 Consignes D'installation

1.8

Securing the refrigerator

1.9

Gas installation

WARNING!
The gas connection shall be carried out by
qualified personnel* only.
* qualified personnel are accredited experts who are
able, by virtue of their training and knowledge, to vouch
for the correct implementation of the leakage test.
Observe the regulations stated in section
6.1 !
This refrigerator is provided for installati−
on within liquid gas equipment and must
be run exclusively on liquid gas (propane,
butane) (no natural gas, town gas).
The pressure regulator must concur with
In the sidewalls of the refrigerator, there are four
plastic sleeves for securing the refrigerator. The
sidewalls or strips attached for securing the
refrigerator must be prepared to hold the screws
firmly in place even when under increased load
(while the vehicle is moving). Fastening screws
and caps are supplied with the refrigerator.
CAUTION!
Always insert screws through the sleeves
provided as otherwise components laid in
foam, such as cables etc., could be damaged.
Fig. E27
After the refrigerator is put in its final place,
secure the screws into the wall of the recess. The
screws must penetrate the casing of the refrige−
rator.
Fig. E28
the operating pressure specified on the
data plate of the appliance. The operating
pressure corresponds to the standard
pressure of the country of specification.
Only one connection pressure is permis
sible for any one vehicle. A plate
showing the permanent, clearly legible
notice must be displayed in full view
at the point where the gas cylinder is
installed.
The gas connection to the appliance must
be installed securely and at zero potential
using tube connectors and must be secu−
rely connected to the vehicle (a hose con−
nection is not permissible).
13