Preparing To Work; Work; At The End Of Work - Fimap Broom Manuel D'utilisation Et D'entretien

1. Remove the appliance and all the accessories from the box
(Fig.1).
2. Insert the lower tube (1) of the handlebar in the hole on the joint
(2). Fix the handlebar to the joint using the screw and nut (3),
making sure the hole (4) on the handlebar coincides with the hole
on the joint (Fig.2)
Warning: the screwdriver is not supplied.
3. Insert the pin (5) of the brush in the slot (6) on the lower part of the
appliance and push it in until the brush is locked in place (Fig.3).
Repeat the operation for the other brush.
1
9
7
8
4
1. Before using the appliance, make sure it is in a good, safe
working condition. If everything is not in order, the appliance must
not be used.
2. Carry out the phases described in the PREPARING TO WORK
chapter.
3. Activate the appliance by means of the button (1).
4. The appliance will now work efficiently until the battery runs down.
1. Switch off the appliance using the button (1) (Fig.1).
2. Take it to the dedicated drainage area.
3. Block the handlebar in the vertical position. Rest your foot on the
main part of the appliance to prevent it from tilting, then push
the handle away from you until it snaps into the vertical position.
Warning: do not rest your foot on the main switch or on the
debris hopper uncoupling lever.
4. To remove the power battery (2) from the appliance, you must first
free it by shifting the stop lever (3) towards the outer part of the
machine. Lift the battery out of the appliance (Fig. 2).

PREPARING TO WORK

13
12
10
11
5

WORK

AT THE END OF WORK

19
4. Insert the dummy battery (7) in its compartment (8) on the right
side of the appliance, making sure the dummy battery fixing pins
are facing towards the rear of the appliance (Fig.4). Press the
dummy battery until the clamp (9) is in place.
5. Insert the battery (10) in its compartment (11) on the left side
of the appliance, making sure the battery poles (12) are facing
towards the front of the appliance (Fig.5). Press the battery until
the clamp (13) is in place.
6. Rotate the stop lever of the command handlebar (14) in the
direction of the arrow (Fig.6). Extend or reduce the length of the
handlebar by means of the handle. The handlebar length must
guarantee a feeling of comfort when using the appliance.
1
4
3
2
3
2
14
6
1
1
5. Release the lever (4) in the debris hopper, using the handle (5),
then remove it from the appliance (Fig.3).
6. Use the handle (5) on the back of the debris hopper to take it to
the drainage area, then empty it.
7. Use a damp cloth to clean the inside and outside of the debris
hopper.
8. Repeat the operations in reverse order to reassemble the debris
hopper.
9. Block the handlebar in the horizontal position. Rest your foot
on the main part of the appliance to prevent it from tilting, then
push the handle away from you until it snaps into the horizontal
position.
6
5
3
ON