Appliance Safety; Preparing To Work; Work - Fimap FB45 Manuel D'utilisation Et D'entretien

APPLIANCE SAFETY

The stages for making the appliance safe, thereby making it possible
to carry out operations safely, are as follows:
1. Check that the main switch (1) is in the "OFF" position, otherwise
turn it anticlockwise as far as it will go.
2. Check that the plug (2) on the power cable (3) has been taken
out of the socket (4) of the mains supply, and if not, disconnect it.
OFF
1
1
Before beginning to work, it is necessary to:
1. Before using, the appliance must be in order and safe to use
with the work equipment, especially the power cable and the
extension cable. If everything is not in order, the appliance must
not be used.
2. Make sure that there is no dirt in the air inlet nozzles (1) (Fig.1).
1
1
To start working, proceed as follows:
1. Make all the checks listed in "PREPARING TO
2. Place the appliance in the position most agreeable to the type of
work to be carried out.
1
3. Insert the plug (2) of the power supply cable (3) in the mains
socket (4) (Fig.1).
4
2
1
4
2
2

PREPARING TO WORK

2
2

WORK

WORK".
1
2
ON
5
3
5
19
3. Wind the power cable under the appliance's lifting handle and
secure it with the clip (5).
ATTENTION: Users are advised to always wear protective
gloves, to avoid the risk of serious injury to hands.
ATTENTION: To prevent damaging the power cable,
disconnect the plug from the mains socket by directly pulling
the plug and not the cable.
5
3
3
3. Make sure that there is no dirt in the air outlet nozzles (2) (Fig.2).
4. Make sure the power supply cable is not damaged.
Fig.1 horizontal position, the air outlet nozzle is perpendicular to the
floor.
Fig.2 tilted position, the air outlet nozzle is inclined upward in relation
to the floor, using lever (1) as a support base
Fig.3 vertical position, the air outlet nozzle is parallel to the floor.
3
4. Turn on the appliance by pressing the main switch (5) (Fig.5).