Warning Pop -Up; Alarms (Table With Reference Codes) - Ravelli Touch Radio Manuel D'utilisation Et D'entretien

ANOMALY (general)
AUTOMATIC CLEANING
SYSTEM ACTIVE

Warning Pop -Up

ANOMALY
SERVICE REQUEST

Alarms (table with reference codes)

TITLE
AL 01 BLACK OUT
SMOKE
AL 02 PROBE
FAILURE
OVERTEMP.
AL 03
SMOKE
AL 04 FAN BROKEN
AL 05 NO IGNITION
AL 06 NO PELLET
RESETTABLE
AL 07 THERMAL
BREAKER
Use and maintenance manual Phandheld Touch Radio
DESCRIPTION
The threshold value of set work hours has been reached. The symbol displayed
remains active throughout the work phase. Non-routine maintenance is required
on the stove.
REASON
No voltage during work phase
The smoke probe is malfunctioning
The smoke probe is disconnected from the
electronic board
Combustion in the fire pot is not optimal due to
clogging or obstructions of internal stove ducts
inside the stove
Fume exhaust encoder is not working or is
connected incorrectly
No power to fume extractor.
The fume extractor is blocked.
The pellet tank is empty.
Pellet calibration and suction during switch on
phase
is incorrect.
The ignition coil is faulty or positioned
incorrectly
The pellet tank is empty.
The gear motor is not loading pellets.
Not enough pellets loaded
The manual reset thermostat connected to the
hopper has been triggered
Combustion in the fire pot is not optimal due to
clogging or obstructions of internal stove ducts
inside the stove
The stove has detected an anomaly; refer to the troubleshooting
chapter.
By pressing the confirmation key, the problem is described.
For models with automatic cleaning system it indicates the
operating state of the same.
SOLUTION
Press the switch off key and switch on the stove
again
If the problem persists, contact the Support Service
Contact the Support Service
Contact the Support Service
Switch off the stove, clean the fire pot and the tube
bundle and adjust the combustion setting the Pellet/
Air values
Contact the Support Service
If the problem persists, contact the Support Service
Contact the Support Service
Contact the Support Service
Contact the Support Service
Check for the presence of pellets in the container.
Top up, if necessary.
Contact the Support Service
Contact the Support Service
Check for the presence of pellets in the container.
Top up, if necessary.
Empty the tank to see if there are any objects inside
that may prevent proper operation of the auger.
Regulate pellets setting from "SET AIR/PELLETS"
If the problem persists, contact the Support Service
Reset the thermostat by pressing the button on the
back of the stove
Switch off the stove, clean the fire pot and the tube
bundle and adjust the combustion setting the Pellet/
Air values
Contact the Support Service
Rev.0 17/05/2021
EN
Pag.39