Double Ducting - Ravelli Touch Radio Manuel D'utilisation Et D'entretien

Rev.0 17/05/2021
EN
Pag.34

Double ducting

This function allows you to manage distribution of warm air between the room where the stove is installed and the rooms where the duct
arrives.
The function has two operating modes: manual and automatic.
Manual mode: the user manually sets distribution of warm air between front ventilation and ductings.
Automatic mode: the stove automatically manages distribution of warm air between front ventilation and ductings, according to the tem-
peratures in the rooms.
Management
The following are the steps to be followed to access the relative menu, starting from the Home screen.
Press the
"Access to menu" key to
access the MENU screen
Press the
"confirm" key to
go to the MANUAL
or AUTO
selection screen
Pressing exit brings you to the CANALIZED menu to set the other function variables in the menu.
Press the key repeatedly to exit the MANAGEMENT screen and to go back to the "Home" screen.
Ventilation (manual mode)
When manual management is active, the power of the ducting can be changed.
MENU
USER
TECHNICIAN
PRODUCER
Press the
"Access to menu"
key to access the
MENU screen
In the VENTILATION item, there is the following screen: the upper line of the display shows the power of the front ventilation, the lower
part of the display shows the distribution of hot air between the ducts.
Use and maintenance manual Phandheld Touch Radio
MENU
USER
TECHNICIAN
PRODUCER
Press the
"confirm" key
to access the
USER screen
CHRONOTHERMOSTAT
Press the
"confirm" key
to access the
USER screen
Use the "UP" and "DOWN" keys to change the power of the front ventilation (the data is
saved without further confirmation). The value can be chosen from 0 (front ventilation off)
to 5. By setting A (auto) the power of the ventilation follows the power of the stove (on
some models this setting can be limited or disabled).
To go back to the CANALIZED menu, press the "back" key.
Use the "confirm" button to switch to setting the distribution of the hot air in the ducting
(REAR)
USER
CANALIZED
LOADING AUGER
CHRONOTHERMOSTAT
SET AIR-PELLET
Press the
"return to menu" key to quit the
screen; press the "selection"
key to go to the "AUTO"
function and activate by
confirming "V"
USER
CANALIZED
LOADING AUGER
SET AIR-PELLET
Press the
"confirm" key
to go to the item
CANALIZED.
Press the "decrease"
key to go to the item
VENTILATION
CANALIZED
MANAGEMENT
TEMPERATURE
VENTILATION
CUBAGE
Press the
STATUS DISPLAY
"confirm" key
to go to the item
CANALIZED.
CANALIZED
MANAGEMENT
TEMPERATURE
VENTILATION
CUBAGE
STATUS DISPLAY
"confirm" key
to access the VEN-
TILATION screen
Press the