Haier HSU-09HRA03/R2 Mode D'emploi page 12

Parts and Functions
If the unit which you purchased has not healthy function, Remote controller should
like the following figure:
Remote controller
1
2
3
5
ON/OFF
13
FAN
MODE
14
SWING
15
TIMER
16
CLOCK
SET SLEEP
17
LOCK RESET
18
1. Operation mode display
Operation mode AUTO COOL
Remote controller
Display board
2. SWING display
3. FAN SPEED display
AUTO
5. SLEEP display
6. LOCK display
Clock set
When unit is started for the first time and after replacing batteries in remote controller,
clock should be adjusted as follows:
Press CLOCK button, "AM" or "PM" flashes.
Press or to set correct time. Each press will increase or decrease 1min. If the
button is kept depressed, time will change quickly.
After time setting is confirmed, press SET, "AM "and "PM" stop flashing, while clock
starts working.
NOTE: Cooling only unit do not have displays and functions related with heating
Hints
After replacing with new batteries, remote controller will conduct self-check, displaying
all information on LCD. Then, it will become normal.
6
7
8
9
10
25
11
7. SIGNAL SENDING display
19
8. TIMER OFF display
9. TIMER ON display
20
10. CLOCK display
11. TEMP display
13. FAN
21
14. SWING
22
15. TIMER
23
16. CLOCK
17. SET
24
18. LOCK
19. POWER ON/OFF
20. TEMP.
21. MODE
22. HOUR
DRY HEAT FAN
23. SLEEP
24. RESET
25. Singal receiver hole
26. Ambient temp.display
LO MED HI
7
Display board
1 26
1
Used to select fan speed LO, MED, HI, AUTO
Used to set auto fan direction.
Used to select TIMER ON, TIMER OFF,
TIMER ON OFF
Used to set correct time
Used to confirm timer and clock settings.
Used to lock buttons and LCD display.
Used for unit start and stop.
Used to select your desired temp.
Used to select AUTO run, COOL, DRY and FAN operation
Used to set clock and timer setting.
Used to select sleep mode.
Used to reset the controller back to
normal condition.
When receiving the remote control signal, display the set
temperature and in the rest time the room temperature is
displayed and this room temperature is only for reference.
8 9
1
5