Stop Switch; Cutting Attachment Guard - Jonsered GT 2228 Manuel D'utilisation

See instructions under the heading "Starting". Start the
machine and apply full throttle. Release the throttle and
check that the cutting attachment stops and remains at a
standstill. If the cutting attachment rotates with the throttle
in the idle position then the carburettor idle setting must
be checked. See instructions under the heading
Maintenance.

Stop switch

Use the stop switch to switch off the engine.
Start the engine and make sure the engine stops when
you move the stop switch to the stop setting.

Cutting attachment guard

This guard is intended to prevent loose objects from being
thrown towards the operator. The guard also protects the
operator from accidental contact with the cutting
attachment.
Check that the guard is undamaged and not cracked.
Replace the guard if it has been exposed to impact or is
cracked.
Always use the recommended guard for the cutting
attachment you are using. See chapter on Technical data.
WARNING! Never use a cutting
!
attachment without an approved guard.
See the chapter on Technical data. If an
incorrect or faulty guard is fitted this can
cause serious personal injury.
GENERAL SAFETY PRECAUTIONS
Muff er
The muffler is designed to keep noise levels to a minimum
and to direct exhaust fumes away from the user.
(Starter housing removed for clarity)
In countries that have a warm and dry climate there is a
significant risk of fir . We therefore fit certain mufflers with
a spark arrestor screen. Check whether the muffler on
your machine is fitted with this kind of screen
For mufflers it is ery important that you follow the
instructions on checking, maintaining and servicing your
machine.
Never use a machine that has a faulty muffle .
Regularly check that the muffler is securely attached to
the machine.
If the muffler on our machine is fitted with a spa k
arrestor screen this must be cleaned regularly. A blocked
screen will cause the engine to overheat and may lead to
serious damage.
WARNING! Muff ers get very hot during
!
use and remain hot for some time
after stopping.
This also applies at idle speed. Contact
can result in burns to the skin.
Remember the risk of fire
WARNING! The inside of the muffler
!
contain chemicals that may be
carcinogenic. Avoid contact with these
elements in the event of a damaged
muffle .
WARNING! The engine exhaust fumes
!
are hot and may contain sparks which
can start a fire. Never start the machine
indoors or near combustible material!
7