Preparation; Installation - Conrad Electronic 85 59 17 Notice D'emploi

Preparation

The four sensors on the front and rear of the vehi-
cle monitor the driving range almost continuously.
The sensors must be installed evenly across the
width of the vehicle.
The illustration shows the sensor range for the
rear and the front.

Installation

In order to install the sensors, you need a drill in order to drill the necessary holes into the bumper.
Prior to drilling, carefully mark the position of the holes.
Make sure that the sensor angle is not obstructed
by vehicle parts. This would lead to malfunc-
tioning.
The ultrasound sensors must be installed evenlyacross the width of the vehicle. The distance between
the sensors may not exceed 30 to 40 cm.
The installation height should be in a range from 50 to 80 cm. Observe the right sequence of the sensors
(code letters „A" to „H"), otherwise it is not possible to display the direction.
20