Camera Control - Abus eyseo. TV7206 Guide D'installation

Camera Control

On this setup page you can configure pan / tilt / zoom cameras (PTZ).
RS485 Settings
Disable The PTZ control is disabled. There will be no control buttons on the main page.
PTZ camera The PTZ control is enabled. On the main page there will appear all PTZ related buttons
and controls.
Transparent HTTP Tunnel In this mode the videoserver routes the UART commands, generated by
the user, through a HTTP tunnel.
Camera ID, PTZ driver (protocol), Baudrate, Data bits, Stop bits and Parity bit must be setup regarding
the PTZ cameras setting.
Preset Position
The user can setup up to 20 preset
positions, which will be stored
inside the dome camera.
The setup positions will appear on
the main screen of the videoserver.
29